School Bus Pre Trip Inspection Study Guide
Free help for the Pre-Trip Inspection for Coach & Transit Bus exam. Our free practice test questions can help you get your CLD the 1st try. No registration! Chock the vehicle or make sure it's on level ground before you begin your pre-trip inspection. ✓ Check to see for any evident damage to the chassis or frame of. Do you think you are prepared to take the AZ CDL Pre-Trip Inspection Exam? If you aren't sure if you'll pass, it is a really bad idea to go to the DMV and sit for the.
During the pre-trip inspection, you must show that the vehicle is safe to drive. You may have to walk around the vehicle and point to or touch each item and explain to the examiner what you are checking and why. You will NOT have to crawl under the hood or under the vehicle. In addition to this section, drivers should also review Section 2 prior to conducting the pre-trip inspection. Drivers need to have knowledge of how the actual vehicle(s) that they are conducting the test in operate. The drivers need to be able to explain and demonstrate different checks for the examiner as requested.
Engine Compartment (Engine Off) Leaks/Hoses:. Look for puddles on the ground. Look for dripping fluids on underside of engine and transmission. Inspect hoses for condition and leaks. Oil Level:. Indicate where dipstick is located.
See that oil level is within safe operating range. Level must be above refill mark. Coolant Level:. Inspect reservoir sight glass, or. If engine is not hot, remove radiator cap and check for visible coolant level. Power Steering Fluid:. Indicate where power steering fluid dipstick is located.
Check for adequate power steering fluid level. Level must be above refill mark. Engine Compartment Belts: Check the following belts for snugness (up to 1/4-inch play at center of belt), cracks or frays:.
Power steering belt. Water pump belt. Alternator belt. Air compressor belt. Cab Check/Engine Start Oil Pressure Gauge:. Make sure oil pressure gauge is working.
Check that pressure gauge shows increasing or normal oil pressure or that the warning light goes off. If equipped, oil temperature gauge should begin a gradual rise to the normal operating range. Temperature Gauge:. Make sure the temperature gauge is working. Temperature should begin to climb to the normal operating range or temperature light should be off.
School Bus Pre Trip Inspection Study Guide
Air Gauge:. Make sure the air gauge is working properly. Build air pressure to governor cut-out, roughly 120-140 psi.
School Bus Pre Trip
Guides and Training Manuals GSF’s training manuals prepare students with the essential information that they need to pass the commercial driver’s license examination. Pre-Trip Inspection Study Guide Exactly what you need to know to pass the DMV Pre-Trip Inspection test. This study guide was created to eliminate the mounds of unnecessary information found in other guides and manuals, and deliver specifically the parts of the pre-trip inspection that are critical for you to know in order to pass the exam. Guaranteed to help you pass the exam!. See an example of our clear and succinct step-by-step guide that prepares you to pass the exam.