Haas Control Manual
Advanced Haas Mill Programming Techniques Training Manual-6/2014. If the spindle is on and the Haas mill controls sees that the part is unclamped (open. All new HAAS VF Series Machining Centers are warranted exclusively by the Haas. Remote Jog Control. Manual Axis Movement. Note: Upper (in), Lower (mm) Common HAAS Mill Panel Controls. Runs One Line of Code and Stops. HAAS Control Panel.
Haas Rotary Control Box Manual
Hi Guys, We have a couple of Haas Indexers (the little 5C collet ones) that we use on verticals with no 4th axis control. Currently we write manual program sheets that go with the NC program and the setup guy manually enters the inder steps into the HAAS control using the pannel. The Vertical Control just sends the one shot signal to the Haas controller when it sees the M code. This is fine for simple stuff, but for the more complex stuff. Well you know.
I'm thinking of a couple improvements. Generate programs for the indexer that would be downloaded into the HAAS controller. EASY solution that would be alittle better than what we do now. Using an RS 232 cable from the Vertical Control to the HAAS Control and Output the HAAS commands from within the Vertical Program.
According to the Haas manual this is possible, The controls on my Vertacals are alittle sketchy about this so I will have to talk to the machine folks. What are you guys doing?
Any experience with number 2 above? And yes I know what you guys with dirrect 4th axis are doing Similar Threads:. Need Help!-. Wish I could offer something useful, but you are obviously way ahead of me. I use an old haas indexer, but it was never used before I came, and all I have been able to make it do is the same single step called up over and over with repeated m21's when I need to rotate the part for holes or whatever. I know the damn thing is capable of much more so I will be watching this thread with great interest!!!
This forum is completely new to me, so I can only hope this somewhat useless offering as a first post isn't inappropriate or anything, usually I lurk for a while in new places, but what the hell!! Something you should know if you happen to be using the early haas indexers, is that they were either stepper motors or open loop, or both, I can't remember for sure. 2016 yamaha yz250 manual.
Anyway, when they stopped they may or may not be at the intended programmed angle. One example would be, if they were rotated too fast for the weight of the attached fixture/part they would stop short or overshoot the programmed angle depending on the situation. My 1st one (new in 1985) had this problem so I always tried to play it safe using a slower rotation feed. Haas improved their indexers and rotary tables to eliminate the problem somtime after that date but I'm not sure when that occured. I sold my old one as soon as the improved ones became available. Paul, That is pretty much what we do now (less the paper tape ) As I understand it the haas is capable of reading instructions through the rs232 port real time (subject to the limitations of RS232). I am trying to get my control to send the instruction via rs232 to the haas.
There by eliminating the separate program and manuscript for the haas. I think I have the answer, but I am waiting on a call from our machine distributor.
This would also allow me to make better use of my programming systems capabilities.